GeForce Series:
GeForce 970 and above
Note:
-
Requires connection to a monitor or the use of a graphics card spoofing tool.
-
Drivers after version 551.23 support a maximum of 8 concurrent streams, drivers after version 531.61 support a maximum of 5 concurrent streams, and older versions support a maximum of two to three concurrent streams. For more concurrent streams, please consult customer service.
Quadro Series:
P4000, P5000, P6000, RTX4000, RTX5000, RTXA5000, etc.
Note:
- Requires connection to a monitor or the use of a graphics card spoofing tool.
Tesla Series:
P40, V100, M60, T4, A10, A40, L4, etc.
Note:
- Requires Grid drivers and corresponding authorization.
Remarks:
-
Installation of GeForce Series Graphics Cards:
-
Visit the NVIDIA official website to download the corresponding driver: NVIDIA Official Driver Download Link
-
During the installation process, select “NVIDIA Graphics Driver,” as shown in the image below:
-
-
T4 Graphics Card Installation Steps:
-
Step One: Apply for authorization (purchase authorization from NVIDIA or its integrators).
-
Step Two: After approval, register the information using the following link: Registration Information Link
-
Step Three: Upon completion of registration, you will receive a response email from NVIDIA within approximately 24 hours. Follow the instructions in the email (set up the authorization server): Authorization Server Setup Operation Link
-
Step Four: Open the NVIDIA Control Panel, go to “Licensing,” select “Quadro Virtual Data…,” and enter the IP and port number of the authorization server:
-
Step Five: Check if the Grid authorization is set up successfully:
-
Open the command prompt, navigate to “C:\Program Files\NVIDIA Corporation\NVSMI”
-
Enter the command:
nvidia-smi.exe -q -
Check if the authorization type is DWS authorization and if the authorization status is displayed as “Authorized”:
-
-